E ECSSystemParts

Komatsu D375A-6 Bulldozer Wiring Harness — All 11 Sections

The Komatsu D375A-6 uses 11 separate harness sections that ECS builds. They are not interchangeable: the part number on your old loom decides which one you need. Below they are grouped by where each section sits on the machine, with the part numbers and the symptoms that point to each group.

11sections listed
$194.00lowest price
$1,500.00highest price
$8,944.90full set value

Which section do I actually need?

Start from the fault, not from the part name. Find the symptom the operator reports, then open that group.

SectionFirst symptom to look forGroup
Chassis HarnessFunctions lost when the machine articulates or steersChassis Harness group
External HarnessSeveral circuits dead after rain or a washExternal Harness group
Fuse Box HarnessThe same fuse blows repeatedlyFuse Box Harness group
Alternator HarnessBattery not charging, warning onAlternator Harness group
Transmission HarnessLimp mode or a single gear onlyTransmission Harness group
Console HarnessConsole buttons dead, machine still runsConsole Harness group
Display HarnessBlank or partial screenDisplay Harness group
Power Distribution HarnessVoltage at the battery but not at the loadPower Distribution Harness group

Chassis Harness 1 part

It runs along the frame between the front and rear of the machine, clipped to the structure and passing articulation or steering joints.

Part #DescriptionPriceStock
195-06-57541Fender Wiring Harness$194.00In stock

External Harness 1 part

It is the outside harness on the machine body — exposed to rain, wash-down, mud and UV. On most machines it is the section most often replaced.

Part #DescriptionPriceStock
195-06-57551Left Front Side Wiring Harness$1200.00In stock

Fuse Box Harness 2 parts

It sits in or immediately behind the fuse and relay box, where battery power is split into the individual circuits.

Part #DescriptionPriceStock
195-06-55581Fuse Box Wiring Harness$1200.00In stock
195-06-84760Cab Fuse Box Wiring Harness (Cold Weather Spec)$1500.00In stock

Alternator Harness 1 part

It is the short charging-circuit harness between the alternator, the battery and the machine harness.

Part #DescriptionPriceStock
6245-81-9311Alternator Wiring Harness$1200.00In stock

Transmission Harness 2 parts

It runs from the transmission control valve and speed sensors up to the ECM or the transmission controller.

Part #DescriptionPriceStock
195-06-55591Powertrain Control Wiring Harness$1200.00In stock
195-15-77200Transmission Wiring Harness$350.90In stock

Console Harness 1 part

It runs from the console or the armrest switch pod into the main cab loom.

Part #DescriptionPriceStock
195-06-55941Right Console Wiring Harness$400.00In stock

Display Harness 1 part

It runs from the display unit in the cab to the machine harness, usually through the dash area.

Part #DescriptionPriceStock
195-06-57610Display Wiring Harness$400.00In stock

Wiring Harness 1 part

Part #DescriptionPriceStock
195-06-55631Radiator Rear Cover Wiring Harness$400.00In stock

Power Distribution Harness 1 part

It is a power distribution section: it carries battery positive or ground from one point on the machine to another, rather than signals.

Part #DescriptionPriceStock
195-06-57620Engine Power Wiring Harness$900.00In stock

Not sure which of the 11 sections is yours?

Send a photo of the tag on your old harness to WhatsApp +86-13714733803 and we will confirm the part number against this list before you order. Getting the section wrong is the most common reason a replacement does not fit.

Ask on WhatsApp Browse all Komatsu parts