E ECSSystemParts

Doosan DX300LC Excavator Wiring Harness — All 4 Sections

The Doosan DX300LC uses 4 separate harness sections that ECS builds. They are not interchangeable: the part number on your old loom decides which one you need. Below they are grouped by where each section sits on the machine, with the part numbers and the symptoms that point to each group.

4sections listed
$299.00lowest price
$1,497.00highest price
$2,963.00full set value

Which section do I actually need?

Start from the fault, not from the part name. Find the symptom the operator reports, then open that group.

SectionFirst symptom to look forGroup
External HarnessSeveral circuits dead after rain or a washExternal Harness group
Engine HarnessIntermittent misfire or a dead cylinderEngine Harness group
Sensor HarnessSeveral sensor codes at the same timeSensor Harness group
Instrument & Interior HarnessOne instrument or accessory deadInstrument & Interior Harness group

External Harness 1 part

It is the outside harness on the machine body — exposed to rain, wash-down, mud and UV. On most machines it is the section most often replaced.

Part #DescriptionPriceStock
530-00409IExternal Wiring Harness$838.00In stock

Engine Harness 1 part

It runs inside the engine compartment, clipped along the block and head and routed past the front cover. On most machines it is the longest harness on the engine side and the one closest to exhaust heat.

Part #DescriptionPriceStock
K1007928AEngine Wiring Harness$329.00In stock

Sensor Harness 1 part

It is the branch that carries pressure, temperature and speed signals from sensors back to the ECM. It usually runs low along the frame or the engine, wherever the sensors are.

Part #DescriptionPriceStock
310207-01704AEngine Sensor Wiring Harness$299.00In stock

Instrument & Interior Harness 1 part

It sits inside the cab, behind the trim, feeding the instruments and controls the operator sees and touches.

Part #DescriptionPriceStock
530-00411GInterior Wiring Harness$1497.00In stock

Not sure which of the 4 sections is yours?

Send a photo of the tag on your old harness to WhatsApp +86-13714733803 and we will confirm the part number against this list before you order. Getting the section wrong is the most common reason a replacement does not fit.

Ask on WhatsApp Browse all Doosan parts