E ECSSystemParts

Caterpillar 320E Excavator Wiring Harness — All 4 Sections

The Caterpillar 320E uses 4 separate harness sections that ECS builds. They are not interchangeable: the part number on your old loom decides which one you need. Below they are grouped by where each section sits on the machine, with the part numbers and the symptoms that point to each group.

4sections listed
$132.00lowest price
$2,024.00highest price
$3,081.00full set value

Which section do I actually need?

Start from the fault, not from the part name. Find the symptom the operator reports, then open that group.

SectionFirst symptom to look forGroup
Main HarnessMany systems affected at the same timeMain Harness group
Engine HarnessIntermittent misfire or a dead cylinderEngine Harness group
Valve Control HarnessOne function slow or dead, others normalValve Control Harness group

Main Harness 1 part

It is the trunk harness: the largest loom on the machine, carrying most circuits between the cab, the engine and the rear structure.

Part #DescriptionPriceStock
369-0165Main Wiring Harness$2024.00In stock

Engine Harness 1 part

It runs inside the engine compartment, clipped along the block and head and routed past the front cover. On most machines it is the longest harness on the engine side and the one closest to exhaust heat.

Part #DescriptionPriceStock
359-1290Engine Wiring Harness$595.00In stock

Valve Control Harness 2 parts

It runs from the control valve block on the frame up to the ECM or the machine controller, clipped along the boom or the frame as it goes.

Part #DescriptionPriceStock
360-6240Control Valve Wiring Harness$330.00In stock
369-0194Solenoid Valve Wiring Harness$132.00In stock

Not sure which of the 4 sections is yours?

Send a photo of the tag on your old harness to WhatsApp +86-13714733803 and we will confirm the part number against this list before you order. Getting the section wrong is the most common reason a replacement does not fit.

Ask on WhatsApp Browse all Caterpillar parts